9. Connect the other end of the optical drive cable to the connector on the rear
of the optical drive.
10. Slide the media-tray front panel and optical drive cage onto the media-tray
base.
Attention: Make sure the optical drive cable is not pinched.
11. Align the screw holes on the optical drive cage with the screw holes on the
media-tray base.
12. Install the screws that you removed in step 2 on page 79.
13. Install the media tray (see "Installing the media tray" on page 47 for more
information).
Chapter 5. Service replaceable units
81