Table of Contents
Advertisement
10. Use your thumb to push and hold the spring down; then, slide the air damper
74
BladeCenter T Type 8267: Hardware Maintenance Manual and Troubleshooting Guide
Spring
7. Use tape to hold the air dampers above and below the empty air damper slot
in the open position. This will provide more room to install the air damper
and reduce the chance of breaking additional air dampers.
8. Turn the air damper on an angle 1 and insert the end with the pins into the
air damper slot in the side panel 2 . Be sure the pins on the air damper are
behind the side panel.
9. Slide the air damper towards the rear of the chassis until it contacts the back
of the slot.
all the way towards the front of the chassis 3 until it contacts the front of
the slot. Be sure the spring is behind the side panel.
Advertisement
Table of Contents
