Table of Contents
Advertisement
Backplane insulator
Complete the following steps to replace the backplane insulator.
Note:
v Read "Installation guidelines" on page 35.
v Read the safety notices in "Safety" on page v.
v Read "Handling static-sensitive devices" on page 37.
1. Perform steps 1 on page 70 through 15 on page 71 in "Backplane" on page 70.
2. Holding the backplane at the top near the guide pins, pull the backplane out
3. Lift the old backplane insulator out of the chassis.
4. Remove the new backplane insulator from its packaging.
5. Install the new backplane insulator over the round alignment studs in the
6. If you have no other replacement procedures to perform at the rear of the
72
BladeCenter T Type 8267: Hardware Maintenance Manual and Troubleshooting Guide
When you have completed these steps, go to step 2 of this procedure.
and off of the guide pins.
Backplane insulator
Screw (6)
Note: The backplane insulator is keyed to the screws and VHDM connectors
and installs in only one correct orientation.
chassis.
system:
v Reinstall the backplane (see page18 on page 71).
v Reinstall the rear chassis stiffener bracket (see "Rear chassis stiffener bracket"
on page 68).
v Reinstall the left and right docking board/blower housing assemblies (see
page 15 on page 68).
v Reinstall the two upper flex circuit assemblies (see page "Upper flex circuit
assembly" on page 64).
v Reinstall the two lower flex circuit assemblies (see page "Lower flex circuit
assembly" on page 66).
Backplane
Advertisement
Table of Contents
