Table of Contents
Advertisement
RJ-45
connector
Complete the following steps to connect the Ethernet cable to the management
module.
1. Connect one end of a Category 5 or higher Ethernet cable to an Ethernet
2. Check the Ethernet LEDs to make sure that the network connection is working.
22
BladeCenter T Type 8267: Hardware Maintenance Manual and Troubleshooting Guide
TOP
D
2
1
2
4
BTM
E
Standard Ethernet
cable
Connect directly to PC
connector on the LAN module. Connect the other end of an Ethernet cable to
the network.
The following illustration shows the locations of the Ethernet LEDs on the LAN
module.
2
1
Ethernet activity
Ethernet link
Ethernet link LED
When this green LED is lit, there is an active connection through the
port to the network.
Ethernet activity LED
When this green LED is flashing, it indicates that there is activity
through the port over the network link.
LAN module
TOP
D
MJR
CRT
MNR
1
3
192.168.70.135
BTM
E
Connect through an Ethernet switch
192.168.70.125
192.168.70.155
Standard
Ethernet
cables
Ethernet switch
Advertisement
Table of Contents
