Table of Contents
Advertisement
7. Start the system (see "Starting the BladeCenter T unit" on page 16).
Air damper
Complete the following steps to replace an air damper.
Note:
v Read "Installation guidelines" on page 35.
v Read the safety notices in "Safety" on page v.
v Read "Handling static-sensitive devices" on page 37.
v Reinstall the rear ac panel (see "Rear panel" on page 63).
v Reinstall the LAN module (see "Installing the LAN module" on page 55).
v Reinstall the KVM module (see "Installing the KVM module" on page 54).
v Reinstall the I/O switches or switch fillers.
v Reinstall the two blowers (see "Installing a blower module" on page 52).
v Plug each power cord into the input power connections on the rear of the
BladeCenter T unit.
v Reinstall the power modules at the front of the BladeCenter T unit (see
"Installing a power module" on page 45).
1. Shut down and remove power from the system (see "Shutting down the
BladeCenter T unit" on page 17).
2. Remove the power modules and fillers from the bays at the front of the unit
(see "Removing a power module" on page 45).
3. Remove the management modules and fillers from the bays at the front of the
unit (see "Removing a management module" on page 49).
4. Remove the media tray from the front of the unit (see "Removing the media
tray" on page 47).
5. Remove the server blades and fillers from the front of the unit (see
"Removing a blade server" on page 62).
6. Remove the broken air damper from the server.
Chapter 5. Service replaceable units
73
Advertisement
Table of Contents
