Using The Reset Button - Panasonic Pure IP-PBX KX-TDE600 Installation Manual

5.1.4 Using the Reset Button

5.1.4 Using the Reset Button
If the PBX does not operate properly, use the Reset Button. Before using the Reset Button, try the system
feature again to confirm whether there definitely is a problem or not.
CAUTION
In order to avoid possible corruption of data on the SD Memory Card, please ensure that the "SD
ACCESS" LED is off before pressing the Reset Button.
Note
•
When the System Initialize Switch is set to "NORMAL", pressing the Reset Button causes the following:
–
Camp-on is cleared.
–
Calls on hold are terminated.
–
Calls on exclusive hold are terminated.
–
Calls in progress are terminated.
–
Call park is cleared.
Other data stored in memory, except the above, are not cleared.
•
Be aware that pressing the Reset Button with the System Initialize Switch in the "SYSTEM
INITIALIZE" position clears all data stored in the PBX. Do not perform this operation unless you intend
to delete all data from the PBX.
Operation
If the PBX does not operate properly:
1.
Slide the System Initialize Switch to the "NORMAL" position.
2.
Press the Reset Button for about 1 second.
218 Installation Manual
RUN Indicator
LED
Reset Button
System Initialize Switch
BATT
ALARM
SD
ACCESS
RESET
SYSTEM
INITIALIZE
NORMAL
Document Version 2009-12