Using The Reset Button - Panasonic KX-TDA100 Installation Manual

4.1.4

Using the Reset Button

If the Hybrid IP-PBX does not operate properly, use the Reset Button. Before using the Reset
Button, try the system feature again to confirm whether there definitely is a problem or not.
Notes
1.
When the System Clear Switch is set to "NORMAL", pressing the Reset Button
causes the following:
•
•
•
•
•
Other data stored in memory, except the above, are not cleared.
2.
When the System Clear Switch is set to the "SYSTEM INITIALIZE" position, you must
press the Reset Button with caution, because all data stored in memory will be
cleared by the following operation: (1) pressing the Reset Button and then, (2) setting
the System Clear Switch to the "NORMAL" position while the RUN indicator is
flashing (within approximately 10 s).
Operation
1.
If the Hybrid IP-PBX does not operate properly:
a.
Make sure that the System Clear Switch is set to the "NORMAL" position.
b.
Press the Reset Button.
2.
If the Hybrid IP-PBX still does not operate properly:
a.
Set the System Clear Switch to the "SYSTEM INITIALIZE" position.
b.
Press the Reset Button.
c.
Return the System Clear Switch to the "NORMAL" position while the RUN indicator is
flashing (within approximately 10 s).
Note
As a result of Step 2, all the programmed data will be cleared.
Camp-on is cleared.
Calls on hold are terminated.
Calls on exclusive hold are terminated.
Calls in progress are terminated.
Call park is cleared.
RUN Indicator
Reset Button
RESET
SYSTEM
INITIALIZE
NORMAL
System Clear Switch
4.1 Troubleshooting
Installation Manual 193