Using The Reset Button - Panasonic KX-TD816 Installation Manual

6.1 Troubleshooting

6.1.4 Using the Reset Button

If the system does not operate properly, use the Reset Button.
(If Master and Slave Systems are in operation by System Connection for KX-TD1232, reset
both systems.)
Before using the Reset Button, try the system feature again to confirm whether there definitely
is a problem or not.
Note
• When the System Clear Switch is set to "NORMAL", pressing the Reset Button causes the
following:
1. Camp-on is cleared.
2. Calls on Hold are terminated.
3. Calls on Exclusive Hold are terminated.
4. Calls in progress are terminated.
5. Call Park is cleared.
All other data stored in memory is not cleared.
• When the System Clear Switch is set to the "CLEAR" position, you must press the Reset
Button with caution. All data stored in memory will be cleared by the following operation:
pressing the Reset Button and setting the System Clear Switch to the "NORMAL" position
while the Power Indicator is flashing.
Operation
1.
If the system does not operate properly,
a)
Make sure that the System Clear Switch is set to the "NORMAL" position.
b)
Press the Reset Button with a pointed tool.
2.
If the system still does not operate properly,
a)
Set the System Clear Switch to the "CLEAR" position.
b)
Press the Reset Button with a pointed tool.
c)
Return the System Clear Switch to the "NORMAL" position while the Power Indicator
is flashing (approximately within 10 seconds).
3.
If the system still does not work, switch the power off and on again after five minutes.
4.
If the system still does not work,
a)
Switch the power off.
b)
Set the System Clear Switch to the "CLEAR" position.
c)
Switch the power on.
d)
Press the Reset Button with a pointed tool.
e)
Set the System Clear Switch to the "NORMAL" position while the Power Indicator is
flashing (approximately within 10 seconds).
5.
If the system still does not work, switch the power off. If car batteries are connected to the
system, disconnect them, too. Then consult an authorised service person.
When the power supply stops, certain extensions are automatically connected straight to
specific outside lines:
182
Troubleshooting