Panasonic Pure IP-PBX KX-TDE600 Installation Manual page 40

1.3.3 System Capacity
Note for KX-NT265 IP-PT users
The supported card varies depending on the software version of your KX-NT265 IP-PT. To confirm the version,
follow the procedure below:
While starting up
PROGRAM
Select
"Maintenance".
SP-PHONE
Power Supply Unit Selection for Each Shelf
The PBX needs a power supply unit (PSU) suitable for its configuration. For each shelf, calculate the load
figure from the type and number of items of equipment to be connected, and then determine the type of PSU
that will be required.
Note
Regardless of the total load figure, if a shelf contains an ECSLC24 card, the PSU-L must be installed.
Load Figure Calculation
PT
Extension Card
*1
CS (1 unit)
High-density CS (1 unit)
IP-CS (1 unit)
VPS (1 port)
Only the extension cards that can support SLTs count for the load figures.
*1
40 Installation Manual
SP-PHONE
Select
"Version display".
To exit the programming mode
HOLD
Software version
is displayed.
Equipment Type
KX-DT300 series DPT/KX-DT300 series DSS
console/KX-T7600 series DPT/KX-T7600 series
DSS console
KX-T7560/KX-T7565 DPT
Other DPT/Other DSS console
APT
IP-PT
SIP Extension
DHLC8
SLC8
ESLC16/CSLC16/EMSLC16
ECSLC24
SP-PHONE
"AP Version".
HOLD HOLD HOLD
Load Figure
1
1
4
4
0
0
8
8
16
24
4
8
0
1
Document Version 2009-12