Rear Shock Pivot - Arctic Cat Wildcat EFI 1994 Service Manual

Fig. 7·64 Fig. 7·66
4. Place the lower shock absorber eyelet into the
rear pivot bracket. Place the lower shock rod
eyelet with bushings into position. Secure the
lower shock rod eyelet and the shock absorber
to the rear pivot bracket with a cap screw, two
washers, and lock nut. Torque to 3.2 kg-m (23
ft-Ib).
NOTE: When installing shock rods, the
longest side of the shock rod eyelet must
be positioned toward the shock absorber.
REAR SHOCK PIVOT
Disassembling
1. Remove the cap screw and lock nut securing
the lower shock absorber eyelet and shock rods
to the pivot tube bracket. Account for the two
shock rod axles.
AG314
2. Remove cap screws and flat washer securing
outer idler wheel. Remove the outer idler wheel
and account for two spacer washers.
3. Slide the inner axle out of the front arm bracket
far enough to remove the rear shock pivot and
account for spacer axle.
Assembling
1. Align the front shock bracket and rear shock
pivot with the spacer installed between the front
arm brackets; then slide the inner axle through
the brackets. Install spacers and outer idler
wheel on the inner axle and secure with a flat
washer and cap screw.
180