Disassembling - Arctic Cat Wildcat EFI 1994 Service Manual

5. Remove the key, alignment washers, and stub
shaft from the driven shaft
DISASSEMBLING
1. Scribe a line across all driven pulley compo­
nents to ensure correct assembly and pulley
balance.
2. Place the driven pulley on a work fixture so the
retainer bracket is directed upward.
Fig. 4-28
NOTE: To aid in driven pulley servicing,
use a roll of duct tape as a work fixture.
The work fixture will increase stability of the
pulley and decrease the spring tension during
the repair procedure.
3. Remove the three lock nuts securing the
retainer bracket; then carefully slide tlie
retainer bracket off the stationary shaft allowing
the spring to release tension.
8456
4. Remove the spring.
8458
5. Slide the movable sheave off the stationary
shaft; then remove the washers located
between the sheaves.
8455
98