Rear Spring - Arctic Cat Wildcat EFI 1994 Service Manual

AG070
REAR SPRING
Removing
1. Remove the set screw from the lock collar
securing the upper idler wheels to the rear arm;
then remove the lock collar.
AG307
2. Using the Idler Wheel Puller Kit (pin 0644-122),
pull the idler wheel from the upper arm.
NOTE: For assembly purposes, scribe a
line on the upper arm tube marking the
location of the idler wheel bearing. Mark the
inside edge of the bearing.
3. Slide the spring and the plastic sleeve off the
rear arm.
4. Repeat these steps for the other rear spring.
Inspecting
NOTE: Whenever a part is worn exces­
sively, cracked, defective, or damaged in
any way, replacement is necessary.
1. Inspect the spring slide, washers, and shaft
area for wear.
2. Inspect the rear adjustment cam for cracks.
Installing
1. Slide the spring and plastic sleeve onto the rear
arm.
2. Position the long spring leg into the spring
slide. Make sure the spring is located above the
spring slide mounting bolt.
168