Arctic Cat Wildcat EFI 1994 Service Manual page 29

AJ148
~.
Fig. 2-69
AJ149
2. Using a pair of snap ring pliers, install the snap
ring which secures the water pump shaft bear­
ing. Make sure the snap ring is seated firmly in
the snap ring groove.
Fig. 2-70
Fig. 2-71
AJ151
When pOSitioning the seal on the driver, check to
make sure the small spring is still in position
around the lip of the seal.
4. Using the seal driver, gently drive the seal down
into position against the snap ring. Check the
seal after the first couple of taps to make sure
it is started straight.
AJ152
5. Apply a thin, even coat of silicone sealer (pin
0636-069) to the outer metal case of the water
pump seal.
3. Apply grease to the inner lips of the small water
pump shaft seal. Position the seal on the seal
driver with the spring side of the seal facing out ­
ward. Make Stlre the small spring located
around the lip of the seal is properly pOSitioned.
27