Removing Taillight Housing; Installing Taillight Housing; Removing Hood - Arctic Cat Wildcat EFI 1994 Service Manual

1. Piace tne inner support tube into the rear
bumper: then place the rear bumper into posi­
tion with its plastic shell between the seat base
and tunnel.
2. Secure the bumper to the sides of the tunnel
using six cap screws and lock nuts. The nuts
must be located on the outside of the tunnel.
3. Secure the bumper to the running boards with
four machine screws and lock nuts. The nuts
should be positioned on the bottom side of the
running board.
4. Slide the snowflap between the plastic shell
and heat exchanger. Secure with three machine
screws and lock nuts.
5. Tighten all bumper mounting hardware. On
standard models, tighten the two lock nuts
securing the rear of the seat base. On Mountain
Cat models, install the tunnel extension cover.
Removing
Taillight Housing
1. Remove the four screws securing the taillight
lens to the housing. Account for a gasket.
2. Remove the two lock nuts and washers secur­
ing the taillight housing. Pull the housing free.
Installing
Taillight Housing
Fig. 6-53
KEY
1. Taillight Ass·y.
2. Bulb
3. Gasket
4. Taillight lens
5. Screw
6. Seat Base Foam
7. Washer
8. lock Nut
0728-384
1. Place the taillight housing into position and
secure with two lock nuts and washers. Tighten
securely.
2. Install taillight bulb, gasket, and lens. Secure
lens with four screws.
Removing Hood
1. Open the hood. Disconnect the headlight wiring
harness connector down near the left hood
hinge.
2. While supporting the hood in the open position,
remove the hood cable.
3. Close the hood; then remove the two hood
hinges pins. Open and lift the hood free of the
snowmobile and place on a clean piece of card ­
board.
NOTE: If the hood is being replaced;
remove the two hood hinges, headlight as­
sembly, and the windshield.
159
"
' ,'
~
I