Removing And Disassembling Throttle Switch; Assembling And Installing Throttle Switch - Arctic Cat Wildcat EFI 1994 Service Manual

Removing and
Disassembling Throttle
Switch
1. Remove the handlebar pad.
2. Remove the retaining ring, seals, washers, and
pin securing the throttle lever to the throttle
switch.
3. Remove the retainer screw and clamp securing
thEi thumb warmer harness to the throttle
sw»ch.
4. Disconnect the throttle cable from the seat in
the throttle lever and remove the lever; then
remove the cable retaining ring and slide the
cable free of the throttle switch.
5. Using a sharp knife, cut the grip off the hand.le­
bar. Using a solvent, clean the old adhesive
from the handlebar.
138
6. Disconnect the throttle switch harness from the
main wiring harness at the front of the steering
post.
7. Remove the tapping screw securing the throttle
switch to the handlebar; then slide the switch
off the handlebar.
r
Assembling and Installing
Throttle Switch
Fig. 6-3
KEY
1. Throttle Switch
2. Screw
3. Seal
4. Washer
I'
5. Retaining Ring
l~
I
~
6. Throttle Lever
4~
7. Pin
5
~
8. Handlebar Grip
~ i
9. Seal
~2
10. Thumb Warmer Element
11. Insulation Pad
12. Clamp
13. Screw
0728·792
1. Slide the throttle switch onto the handlebar:
then secure with a tapping screw.
2. Slide the throttle cable into the groove of throt­
tle switch and secure with a retaining ring.
3. Connect the end of the throttle cable to the seat
of the throttle lever.