Arctic Cat Wildcat EFI 1994 Service Manual page 176

5. Place the front idler wheels and spacers into
Fig. 7-53
position and slide the inner wheel axle
throu~
the idler wheels and front shock bracket.
6. Install the rear spring slide block on the idler
wheel axle and secure with a flat washer and
cap screw. Tighten securely.
Fig. 7-51
AG301
NOTE: Be sure to place the forward cross­
brace tube through the limiter straps.
10. Install the lock nut securing the wear strip to the
slide rail. Tighten securely.
7. Install the bushing into the lower shock eyelet
and place the lower shock eyelet into the lower
shock bracket. Install a cap screw and lock nut.
Tighten securely.
Fig. 7-52
AG298
11. Place the end cap onto the rail and secure with
cap screw, washers, and lock nut.
8. Install the shock pad on the slide rail and
secure with a push pin and a new push nut.
9. Install both front crossbrace tubes between the
slide rails and secure with four cap screws.
Torque to 3.2 kg-m (23 ft-lb).
AG297
177