Arctic Cat Wildcat EFI 1994 Service Manual page 8

II
•
1. Clean the snowmobile thoroughly. Polish the 8. Check brake lever travel, wear indicate' . a~
- _-:
exterior of the snowmobile using Arctco Hood clearance, all controls, headlight.
tal
and Windshield Cleaner Polish (pin 0636-174). brake light, ski alignment, ski wear-bars . . ::.
wear-strips, and headlight aim. Adjust : . .,
2. Remove the cloth from the exhaust system;
replace if necessary.
then check the exhaust system and air silencer
for obstructions.
3. Inspect all control wires and cables for signs of
wear or fraying; replace if necessary. Use cable
ties or tape to route wires and cables away from
hot or rotating parts.
4. Inspect the drive belt for cracks and tears.
Check belt specifications. Replace if damaged
or worn. If the old belt is worn but still in good
condition, keep it in the tool box as a spare in
case of emergency. Install drive belt.
5. Examine fuel hoses and connections for dete ­
rioration, tightness, and cracks; replace as nec ­
essary.
6. Fill the oil-injection tank with Arctco 50:1 Injec­
tion Oil.
7. Check the coolant level and all coolant lines
and connections for deterioration or cracks.
Add properly mixed coolant as necessary.
•
NOTE: Arctco recommends the replace­
ment of all coolant lines every four years
or 4000 miles.
•
9. Inspect throttle cable adjustment.
10. Tighten all nuts, bolts, and screws making sure
all calibrated nuts and bolts are tightened to
specifications.
11. Lubricate the front and rear suspension.
spindles, ball jOints, and speedometer drive
adapter with a low-temperature grease.
12. Check the chain case fluid level. Inspect for
leakage.
13. Check the spark plugs. Clean or replace as
necessary.
14. Charge the battery and test. Install the battery
and clean the connections. Attach the positive
battery cable to the battery positive terminal:
then the negative battery cable to the negative
terminal.
15. Adjust the track to the proper tension and align­
ment.
5