Installing Master Cylinder Housing; Installing Brake Switch - Arctic Cat Panther 1980 Service Manual Supplement

Installing
Master-Cylinder
Housing
Del et e entire section page 91. When installing a
Panther or Pantera brake switch, use the follow-
ing sect ion .
Fig . 6·3
•
BITTlstalling
tBrrake Switch
7
. a
v
•
'
I
•
s_A'
2
KEY
1. Handlebar Grip
2. Brake Lever
3. Brake Switch
4. Retaining Pin
5. Retaining Ring
6. Tapping Screw
7. Parking Brake Actuator
8. Spring
l
0726-210
1. Slide the brake switch into position on the
handlebar; then secure with a tapping screw.
Fig. 6·4
8031
2. SI ide brake cable into position in the brake
switch .
3. Apply petroleum jelly to the end of the cable
and secure to the ''seat'' in the brake lever.
4. Install the parking brake actuator and spring.
Secure actuator, spring, and brake lever to the
brake switch with the retaining pin and retain-
• •
1ng ring.
Fig. 6-5
• •
8030
5. Connect the wiring harness to the brake
switch.
6. Apply Scotch-Grip Industrial Adhesive 847
(p/n
0219-408)
to the bore of the handlebar grip
and using a rubber hammer, drive the grip into
position.
7. Install handlebar pad and secure with cable
ties.
15