Configuring The Transceiver As A Channel-Indication-Mode Unit - Alinco DR-135 Dealer's Manual

2. Configuring the Transceiver
as a Channel-Indication-Mode Unit
You can set the transceiver in the Channel Indication mode either by:
• Setting the pad (BP4) on the printed circuit board of the transceiver
(see "2.1 Setting Up the Transceiver with the Pad BP4"); OR
• Using the DR-135 Channel Data Editor (see "2.2 Setting Up the
Transceiver with the Data Editor").
The CH Data Editor is useful when you want to set up two or more transceivers.
When the transceiver is in the Channel Indication mode, the LCD will look like
the following:
When the Channel contains data:
Note:
2
• The following parameters can be configured with the CH Data Editor:
Enabling/Disabling the SCAN start when the channel is to be
skipped.
Enabling/Disabling power change
Enabling/Disabling the key-lock
Enabling/Disabling MONI key
Enabling/Disabling CTCSS/DCS key
Enabling/Disabling Tone Burst output
• When the above operations are enabled and set, the setting contents
are displayed.