Frequency/Channel Display Mode; Tone Burst Tone - Alinco DJ-A10 Instruction Manual

SET MODE OPERATIONS
5ST: When receives signal, scan stops for 5 seconds and resume.
10ST: Same, 10 seconds.
15ST: Same, 15 seconds and default is 10s.

Frequency/Channel Display Mode

There are 3 different display modes available, Frequency + Channel mode,
Channel mode and Channel+Name Tag modes.
1.Press and hold 【 PF2 】 key while turning on the radio, and keep pressing
【 PF2 】 key for 3 seconds to enter into the Set Mode operations.
2.Press【B】/【C】key to choose the Menu 12 and display " DSP ".
3.Press 【 A 】 key then press 【 B 】 key or 【 C 】 key to choose the parameter.
FREQ: Frequency + Channel mode (VFO mode). Press 【 D 】 key to switch into
VFO mode.
CH: Channel mode. Note that manual setting is not available when the radio has
been preprogrammed by the dealer using software.
NAME: Channel+Name Tag mode(VFO mode). Press 【 D 】 key to switch into
VFO mode.
Default setting is FREQ.

Tone Burst Tone

Especially in Europe, Tone-burst tone operated repeaters are popular. To access to those repeaters,
51
Professional
FM Transceiver