Setting Up The Transceiver With The Pad Bp4 - Alinco DR-135 Dealer's Manual

2.1 Setting UP the Transceiver with the Pad BP4

Before you put the transceiver in the Channel Indication mode, be sure to
program the radio's channel memories following the instructions in the
Instruction Manual provided with the radio. There are additional parameters
that can be programmed manually but are not explained in the Instruction
Manual: for information about these parameters, see "Appendix A" on page 15.
To set up the DR-135
1.
On the transceiver, set the channel data and store the changes in memory,
as needed. See the Instruction Manual for the procedures.
2.
Turn the power off. Remove the bottom cover. Remove Sheet Front panel.
3.
Identify pad BP4 on the printed circuit board. Short-circuit it (or solder a
jumper wire with it).
4.
Refit the Front panel and bottom cover in the proper position. When you
turn the transceiver on, it will be in the Channel Indication mode.
BP4 (solder)
3