Writing The Data In The Transceiver - Alinco DR-135 Dealer's Manual

3.
Changing the Editor option data for Trunking.
Set followings by F3 key in main menu.
SQL No:
TX POWER:
APO:
LAMP Mode:

3.7 Writing the Data in the Transceiver

When you complete editing, store the new data in the transceiver memory.
Caution: • Make sure the COM port (Dsub connector) on the PC is connected to
To write the dala in the transceiver:
1.
On the main menu, press the F4 key. A window will open on the lower-
right of the screen.
2.
Make sure the "Write CH Data (W)" option is highlighted in the window.
Press the Enter key to open the "Wiring the channel data into radio"
window.
3.
Press the space bar. Another message may appear in the window,
however you can ignore it, and press the space bar again.
4.
Turn the transceiver on.
Press the CALL key while holding down the FUNC key.
CLONE is displayed on the display.
5.
Press the space bar to start transferring the data. The message window
will open, telling you the transfer operation is completed successfully.
Press the Enter key to close the window.
6.
Turn the transceiver off to cancel Clone mode.
12
Selects the initial setting value for the squelch level.
Select the output power.
Turn the auto-power-off feature on or off.
Set the lighting mode (High or Low).
the DATA terminal on the radio with the interface cable (ERW-4 or
ERW-4C). If not, turn off the computer and transceiver before
connecting the cable.