Do you have a question about the DR-06T and is the answer not in the manual?
Questions and answers
gail wells
March 2, 2025
is there a simple way of setting the offset and pl tone on a dr-m06
1 comments:
Mr. Anderson
May 14, 2025
To set the offset and PL tone on an Alinco DR-06T, follow these steps:
1. Set the Frequency Offset:
- Press the [FUNC] key, then press the [MHz] key to enter offset mode. - Use the tuning dial or microphone keys to set the desired offset frequency (e.g., 1.6 MHz for 6-meter band repeaters). - Press [FUNC] again to exit offset mode.
2. Set the Transmit Frequency Shift Direction (±):
- Press and hold the [FUNC] key and then press the [SHIFT] key. - Each press of [SHIFT] toggles between +, –, and simplex (no shift). - Choose the appropriate shift direction for your repeater.
3. Set the PL (CTCSS) Tone:
- Press the [FUNC] key, then the [TONE] key to cycle through tone modes: OFF, TONE (encode), TSQL (encode/decode), and CTCSS. - Stop at the desired mode (usually TONE or TSQL for repeater access). - Press and hold the [FUNC] key, then press the [CODE] key to enter the tone frequency setting. - Use the tuning dial or mic keys to select the correct tone frequency (e.g., 100.0 Hz). - Press [FUNC] again to confirm and exit.
Once completed, the radio will transmit with the correct frequency offset and PL tone for repeater access.
Need help?
Do you have a question about the DR-06T and is the answer not in the manual?
Questions and answers
is there a simple way of setting the offset and pl tone on a dr-m06
To set the offset and PL tone on an Alinco DR-06T, follow these steps:
1. Set the Frequency Offset:
- Press the [FUNC] key, then press the [MHz] key to enter offset mode.
- Use the tuning dial or microphone keys to set the desired offset frequency (e.g., 1.6 MHz for 6-meter band repeaters).
- Press [FUNC] again to exit offset mode.
2. Set the Transmit Frequency Shift Direction (±):
- Press and hold the [FUNC] key and then press the [SHIFT] key.
- Each press of [SHIFT] toggles between +, –, and simplex (no shift).
- Choose the appropriate shift direction for your repeater.
3. Set the PL (CTCSS) Tone:
- Press the [FUNC] key, then the [TONE] key to cycle through tone modes: OFF, TONE (encode), TSQL (encode/decode), and CTCSS.
- Stop at the desired mode (usually TONE or TSQL for repeater access).
- Press and hold the [FUNC] key, then press the [CODE] key to enter the tone frequency setting.
- Use the tuning dial or mic keys to select the correct tone frequency (e.g., 100.0 Hz).
- Press [FUNC] again to confirm and exit.
Once completed, the radio will transmit with the correct frequency offset and PL tone for repeater access.
This answer is automatically generated