Alinco DR-135 Dealer's Manual page 10

Rx Freq:
CTCSS / DCS: Set the CTCSS/DCS decoder frequency. Use the Space key to
W/N:
DGT:
DCS DET:
SCN SKP:
PRI:
Tx Freq:
CTSS / DCS:
BCLO:
ANI:
8
Set the reception frequency.
select CTCSS/DCS-off. Press the Enter key from the selected mode
to open the "CTCSS tone or DCS code selection screen".
Set the operating mode (Wide/Narrow).
Set the packet or APRS operation on or off.
Set the DCS decoder detect operation on or off.
Only set this to "ON" when the DCS decoder is operating incorrectly.
Turn the scan skip on or off.
Turn the priority scan on or off. When turning it on ("VFO" appears),
you can select the priority channel. Press the Enter key to open the
"Select ch" box, highlight the priority channel from the list by using
the cursor, Page Up, and Page Down keys, and press the Enter
key to seIect it. The "Select ch" box lists only the active channel
numbers.
For example, suppose the transceiver is on channel 20 and channel
30 has priority. The transceiver then repeats the receiving operations
for five seconds on channel 20 and for 0.5 second on channel 30.
Set the transmission frequency. If you have read channel data
including the frequency shift value from a transceiver, this area
shows the appropriate transmission frequency.
Set the CTCSS/DCS encoder frequency. Use the Space key to
select CTCSS/DCS-off. Press the Enter key from the selected mode
to open the "CTCSS tone or DCS code selection screen".
Turn the BCLO (Busy Channel Lock Out) on or off.
Use this field to enable or disable the ANI (Automatic Numbering
Identification) functions. Usually, set this field to "OFF".