Channel Indication Mode - Alinco DR-135 Dealer's Manual

1. Channel Indication Mode

When the transceiver is in the Channel Indication mode, some functions are
completely disabled, some are programmable only with the Channel Data
Editor software (not programmable with the transceiver switches), and others
are left available. The following table lists the functions provided with the DR-
135 transceiver. Those marked with" "remains active in the Channel
Indication mode.
Transmission
Monitor
Set mode
Changing VFO frequency
Scanning memories
Calling up a call channel
Auto dialer
Volume level control
Adjusting squelch
Setting tuning step
Setting frequency and offset
Setting tone squelch(CTCSS)
Setting digital code squelch(DCS)
Setting output power
programming auto dialer memories
Programming memory channels
Setting key-lock
Setting memories skip channels
*1 : This function is programmable with the CH Data Editor software (not programmable with the
transceiver switches) and disabled by default.
*2 : This function is programmable with the CH Data Editor software (programmable with the
transceiver switches) and disabled by default.
(The CH Data Editor software can be used to make it possible to operate this function using
the transceiver switches.)
Installed
EJ-39D
Naming channel memories
Cloning
*2
Tone burst transmission
Resetting CPU
Programming ANI
*2
Setting scanning mode
Setting beep sound
Programming BCLO
Programming TOT
Programming TOT penalty
*1 *1 Setting APO
Setting tone burst frequency
*2 *1
*2 *1 Setting DTMF wait time
*2 *2 Setting DTMF pause/burst time
Setting DTMF first burst time
*1
Setting theft alarm
*1 *1
*2 *1 Setting Lamp mode
*1 *1 Power supply voltage display function
Installed
EJ-39D
*1 *1
*2
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1 *1
*1
1