Automatic Numbering Identification (Ani); Priority Watch (Pri); Appendix A - Alinco DR-135 Dealer's Manual

Appendix A

A.1 Automatic Numbering Identification (ANI)
This feature allows the transceiver to automatically send the programmed
DTMF codes (up to 16 digits) just after the
released so that the base station can identify the unit.
Two auto dialer memories, Nos. 8 and 9, are reserved for the ANI transmission.
You can enable or disable the ANI function by using the Channel Data Editor
software.
• When memory No. 8 contains DTMF codes, the transceiver sends the codes
just after the
• When memory No. 9 contains DTMF codes, the transceiver sends the codes
just after the
• When both Nos. 8 and 9 contains DTMF codes, the transceiver sends the
codes immediately after the
• When memory Nos. 8 and 9 are empty, the transceiver does not output any
DTMF code when the
Examples are given in the table below.
DTMF codes in dialer memories
A.2 Priority Watch (PRI)
Priority Watch monitors a channel different from the indicated frequency.
Every 5 seconds, the transceiver switches from the indicated frequency to the
priority channel.
If a signal is received on the priority channel, the reception time is extended to
2 seconds.
To stay in Priority channel, push
key is pressed.
key is released.
key is pressed or released.
No. 8 No. 9
- -
8888 -
- 9999
8888 9999
key is pressed and/or
key is pressed and released.
DTMF codes to be sent
Just after Just after
is pressed is released
-
8888
-
8888
key when Priority channel is on.
-
-
9999
9999
15