Setting Up The Transceiver With The Ch Data Editor - Alinco DR-135 Dealer's Manual

2.2 Setting Up the Transceiver with the CH Data Editor

This section describes how to configure the transceiver as a Data-Indication-
mode unit with the CH Data Editor software.
The function of "Appendix A" (on page 15) can be programmed only through
CH Data Editor software.
To set up the transceiver with the CH Data Editor:
1.
Connect the COM port (Dsub connector) on your computer to the external
speaker jack on the transceiver with the ERW-4 or ERW-4C interface
cable.
DATA terminal
2.
Start the Channel Data Editor on your computer. On the main menu, press
the F3 key, and select the "Radio Option (R)" option. In the "Edit option
data" window, select the "Channel" option in the "Indication Mode" field.
Write your changes in the transceiver memory. The transceiver will then
enter the Channel Indication mode. For more information about using the
software, see chapter 3 "DR-135 Channel Data Editor".
4
DR-135
(Front panel)
ERW-4 or ERW-4C interface cable
Computer