2.11 Starting the Hybrid IP-PBX
2.11.1 Starting the Hybrid IP-PBX
CAUTION
•
SD Memory Card must be inserted in the SD Memory Card slot of the main board
before start up.
•
Before touching the System Initialize Switch, discharge static electricity by touching
ground or wearing a grounding strap.
•
Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do
not perform the following procedures to start the Hybrid IP-PBX again. Otherwise,
your programmed data is cleared. To restart the Hybrid IP-PBX, refer to "4.1.4 Using
the Reset Button".
•
The Hybrid IP-PBX will continue to be powered even if the power switch is turned
"OFF".
•
The power supply cord is used as the main disconnect device, ensure that the socket-
outlet is located/installed near the equipment and is easily accessible.
1.
Set the System Initialize Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
ALARM Indicator
2.11 Starting the Hybrid IP-PBX
Reset Button
System Initialize Switch
Installation Manual
119