2.10 Starting the Hybrid IP-PBX
2.10.1 Starting the Hybrid IP-PBX
CAUTION
•
SD Memory Card must be inserted in the SD Memory Card slot of the main board
before start up.
•
Before touching the System Initialise Switch and the Reset Button, discharge static
by touching ground or wearing an earthing strap.
•
Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do
not perform the following procedures to start the Hybrid IP-PBX again. Otherwise,
your programmed data is cleared. To restart the Hybrid IP-PBX, refer to "4.1.4 Using
the Reset Button".
•
The Hybrid IP-PBX will continue to be powered even if the power switch is turned
"OFF".
•
The power supply cord is used as the main disconnect device, ensure that the socket-
outlet is located/installed near the equipment and is easily accessible.
1.
Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
ALARM Indicator
2.10 Starting the Hybrid IP-PBX
Reset Button
System Initialise Switch
Installation Manual
121