2.13 Starting the Hybrid IP-PBX
2.13.1 Starting the Hybrid IP-PBX
CAUTION
•
SD Memory Card must be inserted in the SD Memory Card slot of the MPR card before start up.
•
Before touching the System Initialise Switch, discharge static electricity by touching ground or
wearing an earthing strap.
•
Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do not perform the
following procedures to start the Hybrid IP-PBX again. Otherwise, your programmed data is
cleared. To restart the Hybrid IP-PBX, refer to "4.1.4 Using the Reset Button".
•
The Hybrid IP-PBX will continue to be powered even if the power switch is turned "OFF".
•
The power supply cord is used as the main disconnect device, ensure that the socket-outlet is
located/installed near the equipment and is easily accessible.
1.
Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
Reset Button
System Initialise Switch
RESET
SYSTEM
INITIALIZE
NORMAL
2.13 Starting the Hybrid IP-PBX
Installation Manual
209