Starting The Hybrid Ip-Pbx - Panasonic KX-TDA600 - Hybrid IP PBX Control Unit Max. 1008 Ports Installation Manual

2.14 Starting the Hybrid IP-PBX

2.14.1 Starting the Hybrid IP-PBX
Before Starting the Hybrid IP-PBX
Before starting the Hybrid IP-PBX, please pay attention to the following points:
• SD Memory Card
The SD Memory Card must be inserted in the SD Memory Card slot of the EMPR card before
startup.
• Bus Cable
Pull the Bus Cables in order to make sure that they are connected securely to the shelves. If the
Bus Cables detach or are loose, plug them in to the shelves again, confirming that the clasps on
the Bus Cable attach securely to the connector of the BUS-S or BUS-M card.
Starting the Hybrid IP-PBX
CAUTION
• Before touching the System Initialize Switch, discharge static electricity by touching ground or
wearing a grounding strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do not perform the
following procedures to start the Hybrid IP-PBX again. Otherwise, your programmed data is
cleared. To restart the Hybrid IP-PBX, refer to "4.1.4 Using the Reset Button".
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned "OFF".
• The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
1.
Slide the System Initialize Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
Reset Button
INITIALIZE
System Initialize Switch
2.14 Starting the Hybrid IP-PBX
RESET
SYSTEM
NORMAL
Installation Manual 205