Starting Up; Shoulder Strap Adjustment - InfraTec VarioCAM User Manual

7

Starting up

7.1

Shoulder Strap Adjustment

How to fix the shoulder strap is explained in the following figures:
Fig. 10 Step 1:
The lace is to be pulled through
the flap at the back of the
camera by approx. 10 cm from
the top.
Fig. 13 Step 4:
The longer side of the lace is to
be loosened at the fastener.
The loose end of the strap should always show ≥ 5 cm beyond the fastener!
16
User Manual for the Thermographic System VarioCAM
Fig. 11 Step 2:
The loose end of the lace is pulled through the sleeve which then is
pressed against the flap of the camera.
Fig. 14 Step 5:
Then the short side of the lace
is also pulled through
fastener and tightened, so that
only one flap is to be seen.
© InfraTec GmbH 2013
Fig. 12 Step 3:
Fig. 15 Last step:
The long, upper side of the lace is
the pulled through the fastener and
tightened, so that no flap is to be
seen any longer.
® high resolution
7. Starting up
User Manual