Power Supply - InfraTec VarioCAM User Manual

Power supply

®
The VarioCAM hr has the following power supply options:
■ External power supply unit 12 V*
■ Li-ion rechargeable battery 7.2 V or
■ FireWire (IEEE 1394) interface*.
The mains adapter is connected to the 14-pin (left) socket at the rear of the camera. The rechargeable
battery is put upright into the place provided at the rear of the thermographic system (see chapter 6.2,
page 12).
For devices equipped with a FireWire (IEEE 1394) interface, the supply voltage can be taken directly from
the PC interface card. Please note the specification of the used interface card and the power input of the
thermographic system. In case of cable lengths > 5 m, power should principally be supplied via the
external power supply unit or the rechargeable battery.
Interfaces
The thermographic system has the following interfaces:
■ SD slot
■ RS232*
■ Composite Video, S Video, VGA
■ Input for external trigger signal/trigger output* (TTL/CMOS, 5 V)
■ FireWire (IEEE 1394)*
■ Headset socket*
■ WLAN*
With the exception of FireWire (IEEE 1394), Headset and WLAN, parallel use of all interfaces is possible
by means of a Breakout Box. The Breakout Box* is connected to the thermographic system with a 14-pin
system cable*. Voltage is then supplied to the Breakout Box from the external power supply unit*. The
analog image information is available as Composite Video, S-Video or VGA signal. Suitable monitors can
be connected to the Breakout Box with standard cables (see Chapter 7.8, Operation with Breakout Box
(Connection via RS232)*, page 20).
The FireWire (IEEE 1394) interface*, in connection with the software packages IRBIS
®
IRBIS online*, permits to remote-control the thermographic system and the real-time transfer* of digital
image information to a PC.
8
User Manual for the Thermographic System VarioCAM
© InfraTec GmbH 2013
® high resolution
3. Technical Description
®
remote* and
User Manual