InfraTec VarioCAM User Manual page 23

User Manual for the Thermographic System VarioCAM
7. Starting up
When connecting the thermographic camera with the PC/notebook for the first time, automatic hardware
recognition will be activated. Further steps for installing the FireWire (IEEE1394) driver for the VarioCAM
are described in Chapter 9.3, Installation of the FireWire Driver for the VarioCAM
Connection with a power supply unit*
Fig. 21 Power supply unit with plug
Fig. 22 LEMO adapter
Connection without a power supply unit
VarioCAM®
hr
Battery
14 6
LEMO
Fig. 23 VC hr with FireWire cable (and
battery)
Should the thermographic system VarioCAM
(power supply via the FireWire interface), make sure that the FireWire cards recommended by
InfraTec are used. Otherwise InfraTec will not grant any functional guaranty.
User Manual
® high resolution
When operating the VarioCAM
(FireWire connection without any power supply), the
thermographic system is to be connected via a power
supply unit by means of the 14-pin LEMO plug.
As an alternative, power can also be supplied via the 6-
pin LEMO socket on the right at the rear of the
VarioCAM
the LEMO adapter is connected to the power supply unit.
VC hr with FireWire cable (and battery)
The VarioCAM
with the 6-pin LEMO socket on the right (each marked
yellow). The VarioCAM
battery or the FireWire cable. An external power supply
unit is not required in this case.
FireWire
®
© InfraTec GmbH 2013
®
hr or of the Breakout Box. For this purpose,
®
hr is connected via the FireWire cable
®
hr is supplied with power via the
hr be operated on a PC without any power supply unit
®
®
hr, page 68.
®
hr on a notebook
hr
19