Yamaha YZFR6X(C) 2008 Service Manual page 379

Fault code No. 23
Diagnostic code No.
Item/components and probable
Order
cause
1 Connections
• Atmospheric pressure sensor cou-
pler
• Main wire harness ECU coupler
2 Open or short circuit in wire harness
and/or sub-wire-harness 2.
3 Defective atmospheric pressure sen-
sor.
Fault code No. 24
Diagnostic code No.
Item/components and probable
Order
cause
1 Installed state of O
2 Connections
• O sensor coupler
2
• Main wire harness ECU coupler
3 Open or short circuit in wire harness.
4 Check fuel pressure.
5 Defective O sensor.
2
Atmospheric pressure sensor: open or short circuit
Symptom
detected.
02 Atmospheric pressure sensor
Check or maintenance job
• Check the couplers for any pins
• Check the locking condition of
• If there is a malfunction, repair
• Repair or replace if there is an
• Between atmospheric pressure
• Execute the diagnostic mode.
• Replace if defective.
Symptom No normal signal is received from the O
— —
Check or maintenance job
sensor. Check for looseness or pinching. Execute the
2
• Check the couplers for any pins
• Check the locking condition of
• If there is a malfunction, repair
• Repair or replace if there is an
• Between O
• Refer to "THROTTLE BOD-
• Replace if defective.
8-56
FUEL INJECTION SYSTEM
that may be pulled out.
the couplers.
it and connect the coupler
securely.
open or short circuit.
sensor coupler and ECU cou-
pler.
(black/blue–black/blue)
(pink–pink)
(blue–blue)
(Code No. 02)
Refer to "CHECKING THE
ATMOSPHERIC PRESSURE
SENSOR" on page 8-99.
that may be pulled out.
the couplers.
it and connect the coupler
securely.
open or short circuit.
sensor coupler
2
and ECU coupler.
(gray/green–gray/green)
(black/blue–black/blue)
(black–black)
(red/blue–red/blue)
IES" on page 7-9.
Reinstatement
method
Reinstated
automatically if
a normal signal
is received.
sensor.
2
Reinstatement
method
diagnostic
mode (Code
No. 63).
(Set the engine
stop switch to
" ".)