Yamaha YZFR6X(C) 2008 Service Manual page 53

Item
Front cowling assembly bolt
Seat lock assembly bolt
Rider seat and frame
Battery box and frame
Rear upper cowling damper plate
and frame
License plate light assembly bolt
Rider footrest (left and right)
assembly bolt
Passenger footrest (left and right)
bolt
Rear brake master cylinder bolt
Sidestand assembly and frame
bolt
Coupler holder (left and right) and
frame bolt
Shift arm bolt
Locknut (shift rod upper side)
Locknut (shift rod lower side)
NOTE:
Front wheel axle pinch bolt
1. Insert the front wheel axle from the right side and tighten it with the flange bolt from the left side
to 91 Nm (9.1 m·kg, 66 ft·lb) without performing temporary tightening.
2. In the order pinch bolt "2" → pinch bolt "1" → pinch bolt "2", tighten each bolt to 21 Nm (2.1 m·kg,
15 ft·lb) without performing temporary tightening.
3. Check that the right end of the front axle is flush with the front fork. If necessary, manually push
the front axle or lightly tap it with a soft hammer until its end is flush with the front fork. However,
if the surface of the front axle end is not parallel to the surface of the front fork, align a point on
the outer edge of the axle with the fork, making sure that the axle does not protrude past the
fork.
4. In the order pinch bolt "4" → pinch bolt "3" → pinch bolt "4", tighten each bolt to 21 Nm (2.1 m·kg,
15 ft·lb) without performing temporary tightening.
Threa
Q'ty
d size
M6 4 13 Nm (1.3 m·kg, 9.6 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.2 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.2 ft·lb)
M6 2 4 Nm (0.4 m·kg, 3.0 ft·lb)
M6 4 7 Nm (0.7 m·kg, 5.2 ft·lb)
M6 4 7 Nm (0.7 m·kg, 5.2 ft·lb)
M8 4 28 Nm (2.8 m·kg, 21 ft·lb)
M8 4 28 Nm (2.8 m·kg, 21 ft·lb)
M6 2 13 Nm (1.3 m·kg, 9.6 ft·lb)
M8 3 26 Nm (2.6 m·kg, 19 ft·lb)
M6 4 7 Nm (0.7 m·kg, 5.2 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.4 ft·lb)
M6 1 7 Nm (0.7 m·kg, 5.2 ft·lb)
M8 1 10 Nm (1.0 m·kg, 7.4 ft·lb)
4
3
2-22
TIGHTENING TORQUES
Tightening torque
1
2
Remarks
LS
LT
LT