b. Correct
1. Drive chain roller
2. Rear wheel sprocket
2. Replace:
• Rear wheel sprocket
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the self-locking nuts and the rear
wheel sprocket.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact
the sprocket.
c. Install the new rear wheel sprocket.
Rear wheel sprocket self-lock-
ing nut
100 Nm (10.0 m·kg, 74 ft·lb)
NOTE:
Tighten the self-locking nuts in stages and in a
crisscross pattern.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS22140
ASSEMBLING THE REAR WHEEL
1. Install:
• Wheel bearings
New
• Oil seals
New
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-9.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel or both, the
rear wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT
WHEEL STATIC BALANCE" on page 4-9.
ET2C01004
CHECKING THE REAR BRAKE DISC
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-35.
EAS22160
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install:
• Rear brake disc
Rear brake disc bolt
30 Nm (3.0 m·kg, 22 ft·lb)
LOCTITE
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-35.
3. Lubricate:
• Rear wheel axle
• Wheel bearings
• Oil seal lips
• Collars
Recommended lubricant
Lithium-soap-based grease
4-16
REAR WHEEL
®