Checking The Starter Motor - Yamaha YZFR6X(C) 2008 Service Manual

EAS24790

CHECKING THE STARTER MOTOR

1. Check:
• Commutator
Dirt → Clean with 600 grit sandpaper.
2. Measure:
• Commutator diameter "1"
Out of specification → Replace the
starter motor.
Limit
27.0 mm (1.06 in)
3. Measure:
• Mica undercut "a"
Out of specification → Scrape the mica to
the proper measurement with a hacksaw
blade that has been grounded to fit the
commutator.
Mica undercut (depth)
0.70 mm (0.03 in)
NOTE:
The mica of the commutator must be undercut
to ensure proper operation of the commutator.
4. Measure:
• Armature assembly resistances (commu-
tator and insulation)
Out of specification → Replace the
starter motor.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Measure the armature assembly resis-
tances with the pocket tester.
ELECTRIC STARTER
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Armature coil
Commutator resistance "1"
0.0012–0.0022 Ω at 20 °C (68
°F)
Insulation resistance "2"
Above 1 MΩ at 20 °C (68 °F)
b. If any resistance is out of specification,
replace the starter motor.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Measure:
• Brush length "a"
Out of specification → Replace the
brushes as a set.
Limit
3.50 mm (0.14 in)
6. Measure:
• Brush spring force
Out of specification → Replace the brush
springs as a set.
Brush spring force
7.16–9.52 N (25.77–34.27 oz)
(730–971 gf)
5-34