Checking The Coolant Level - Yamaha YZFR6X(C) 2008 Service Manual

position). If the projection does not contact the
stopper, adjust the EXUP cable free play.
a
b
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Check:
• EXUP cable free play (at the EXUP valve
pulley) "a"
Out of specification → Adjust.
EXUP cable free play (at the
EXUP valve pulley)
1.5 mm (0.06 in) or less
a
4. Adjust:
• EXUP cable free play
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen the locknuts "1" and "2".
b. Turn the adjusting bolt "3" in direction "a" or
"b" until the specification.
Direction "a"
Free play is increased.
Direction "b"
Free play is decreased.
EXUP cable free play (at the
EXUP valve pulley)
c: 1.5 mm (0.06 in) or less
c. Tighten the locknut "1" to specification.
Locknut (EXUP cable adjusting
bolt)
6 Nm (0.6 m·kg, 4.4 ft·lb)
d. Turn the adjusting bolt "4" in direction "a" or
"b" until the specification.
Direction "a"
Free play is increased.
Direction "b"
Free play is decreased.
EXUP cable free play (at the
EXUP valve pulley)
d: 1.5 mm (0.06 in) or less
e. Tighten the locknut "2" to specification.
Locknut (EXUP cable adjusting
bolt)
6 Nm (0.6 m·kg, 4.4 ft·lb)
1
2
f. Repeat steps (2) and (3).
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Install:
• EXUP valve pulley cover
EXUP valve pulley cover bolt
(front side)
8 Nm (0.8 m·kg, 5.9 ft·lb)
EXUP valve pulley cover bolt
(rear side)
7 Nm (0.7 m·kg, 5.2 ft·lb)
EAS21110

CHECKING THE COOLANT LEVEL

1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on a suitable stand.
• Make sure the vehicle is upright.
2. Check:
• Coolant level
The coolant level should be between the
maximum level mark "a" and minimum
level mark "b".
Below the minimum level mark →
Remove the coolant reservoir cap, add
3-18
ENGINE
3
c
a
b
a
b
d
4