Yamaha YZFR6X(C) 2008 Service Manual page 254

• Clutch cover gasket
• Clutch cover "1"
Clutch cover bolt
12 Nm (1.2 m·kg, 8.9 ft·lb)
NOTE:
• Position the pull rod so that the teeth "a" face
towards the rear of the vehicle. Then, install
the clutch cover.
• Apply locking agent (LOCTITE
threads of only the clutch cover bolts "a"
shown in the illustration.
• Tighten the clutch cover bolts in stages and
in a crisscross pattern.
10. Install:
• Pull lever spring "1"
• Pull lever "2"
• Washer
• Circlip
New
NOTE:
• Make sure that the mark "a" on the pull lever
is facing up.
• When installing the pull lever, push it and
check that its punch mark "b" aligns with the
mark "c" on the clutch cover. Make sure that
the pull rod teeth and pull lever shaft pinion
gear are engaged.
11. Adjust:
• Clutch cable free play
New
®
) to the
1
a
c
1
2
a
b
5-45
Refer to "ADJUSTING THE CLUTCH
LEVER FREE PLAY" on page 3-14.
CLUTCH