Yamaha YZFR6X(C) 2008 Service Manual page 18

5. Push the "RESET" button to set the min-
utes.
6. Push the "SELECT" button and then
release it to start the clock.
Odometer, tripmeter, and stopwatch modes
1. Odometer/tripmeters/fuel reserve tripmeter/
stopwatch
Push the "SELECT" button to switch the dis-
play between the odometer mode "ODO", the
tripmeter modes "TRIP A" and "TRIP B" and
the stopwatch mode in the following order:
TRIP A → TRIP B → ODO → Stopwatch →
TRIP A
If the fuel level warning light comes on, the
odometer display will automatically change to
the fuel reserve tripmeter mode "F-TRIP" and
start counting the distance traveled from that
point. In that case, push the "SELECT" button
to switch the display between the various trip-
meter, odometer, and stopwatch modes in the
following order:
F-TRIP → Stopwatch → TRIP A → TRIP B →
ODO → F-TRIP
To reset a tripmeter, select it by pushing the
"SELECT" button, and then push the "RESET"
button for at least one second. If you do not
reset the fuel reserve tripmeter manually, it will
reset itself automatically and the display will
return to the prior mode after refueling and
traveling 5 km (3 mi).
Stopwatch mode
To change the display to the stopwatch mode,
select it by pushing the "SELECT" button. (The
stopwatch digits will start flashing.) Release
the "SELECT" button, and then push it again
for a few seconds until the stopwatch digits
stop flashing.
Standard measurement
1. Push the "RESET" button to start the stop-
watch.
2. Push the "SELECT" button to stop the stop-
watch.
3. Push the "SELECT" button again to reset
the stopwatch.
Split-time measurement
1. Push the "RESET" button to start the stop-
watch.
2. Push the "RESET" button or start switch
" " to measure split-times.
(The colon ":" will start flashing.)
3. Push the "RESET" button or start switch
" " to display the final split-time or push
the "SELECT" button to stop the stopwatch
and display total elapsed time.
4. Push the "SELECT" button to reset the
stopwatch.
NOTE:
To change the display back to the prior mode,
push the "SELECT" button for a few seconds
until the stopwatch digits flash.
Coolant temperature display
1. Coolant temperature display
The coolant temperature display indicates the
temperature of the coolant.
Push the "RESET" button to switch the coolant
temperature display to the air intake tempera-
ture display.
NOTE:
When the coolant temperature display is
selected, "C" is displayed for one second, and
then the coolant temperature is displayed.
ECA13S1002
CAUTION:
Do not operate the engine if it is over-
heated.
1-9
FEATURES