Yamaha YZFR6X(C) 2008 Service Manual page 20

To adjust the brightness of the multifunction
meter displays and tachometer
1. Turn the key to "OFF".
2. Push and hold the "SELECT" button.
3. Turn the key to "ON", and then release the
"SELECT" button after five seconds.
4. Push the "RESET" button to select the
desired brightness level.
5. Push the "SELECT" button to confirm the
selected brightness level. The control
mode changes to the shift timing indicator
light activity function.
To set the shift timing indicator light activity
function
1. Push the "RESET" button to select one of
the following indicator light activity settings:
• The indicator light will stay on when acti-
vated. (This setting is selected when the
indicator light stays on.)
• The indicator light will flash when acti-
vated. (This setting is selected when the
indicator light flashes four times per sec-
ond.)
• The indicator light is deactivated; in other
words, it will not come on or flash. (This
setting is selected when the indicator light
flashes once every two seconds.)
2. Push the "SELECT" button to confirm the
selected indicator light activity. The control
mode changes to the shift timing indicator
light activation function.
To set the shift timing indicator light activation
function
NOTE:
The shift timing indicator light activation func-
tion can be set between 10000 r/min and
18000 r/min. From 10000 r/min to 13000 r/min,
the indicator light can be set in increments of
500 r/min. From 13000 r/min to 18000 r/min,
the indicator light can be set in increments of
200 r/min.
1. Push the "RESET" button to select the
desired engine speed for activating the
indicator light.
2. Push the "SELECT" button to confirm the
selected engine speed. The control mode
changes to the shift timing indicator light
deactivation function.
To set the shift timing indicator light deactiva-
tion function
NOTE:
• The shift timing indicator light deactivation
function can be set between 10000 r/min and
18000 r/min. From 10000 r/min to 13000
r/min, the indicator light can be set in incre-
ments of 500 r/min. From 13000 r/min to
18000 r/min, the indicator light can be set in
increments of 200 r/min.
• Be sure to set the deactivation function to a
higher engine speed than for the activation
function, otherwise the shift timing indicator
light will remain deactivated.
1. Push the "RESET" button to select the
desired engine speed for deactivating the
indicator light.
2. Push the "SELECT" button to confirm the
selected engine speed. The control mode
changes to the shift timing indicator light
brightness function.
To adjust the shift timing indicator light bright-
ness
1. Push the "RESET" button to select the
desired indicator light brightness level.
2. Push the "SELECT" button to confirm the
selected indicator light brightness level.
The right display will return to the odometer
or tripmeter mode.
1-11
FEATURES