Advertisement
How to Use
Your Dual Range
Touch-A-Matic 14
or
"Pulse-Matic" 16
Blender
DDDDDDDDDD
The processing speeds of these blenders are controlled by the pushbuttons, the
TOUCH-N-PULSE or TOUCH-A-MATIC button and the rotary switch marked
PULSE'OFF/ON. The LO button controls the speeds marked below the buttons.
The HI button controls the speeds marked above the buttons. The rotary switch
marked PULSE«OFF/ON controls blending action.
FOR CONTROLLED CYCLE OPERATION
With rotary switch in PULSE»OFF position, rest hand on container. Select and
press proper speed and speed range (HI and LO) button. Then press TOUCH-N-
PULSE or TOUCH-A-MATIC button and hold in for about 2 seconds. Release
button and allow blades to coast to a stop. Repeat for number of cycles as specified
in recipe. Release of the TOUCH-N-PULSE (TOUCH-A-MATIC) button tums the
blender off.
CONTINUOUS OPERATION
Rest hand on container, press speed and range buttons. Move rotary switch to ON
position. When processing is finished, move rotary switch to PULSE»OFF position.
How to Use
Your Dual
'Pulse-Matic"
16 Speed
Blender
Cher
/ ^ ^
[Z:DD
\ : ^
dual • puiaa • matte
I B
|»'^"*»'fc"»**"'
D D D D D D D D
The speeds of your Dual "Pulse-Matic" blender are controlled by the pushbuttons
on the lower control panel of the blender and three pushbuttons and a rotary switch
on the upper control panel.
The lower buttons control the speeds of the blender. The rotary switch selects the-
range of operating (HI—red; LO—yellow). The upper pushbuttons activate the
blender. The ON button Is used for continuous operation. The OFF button is used to
tum the motor off, and the pulse button is used for "Cycle Operation" on the speed
selected.
FOR CONTROLLED CYCLE OPERATION
Rest hand on container, select and press proper speed button. Move rotary switch
to proper speed range. Press PULSE button and hold in for about 2 seconds.
Release button and allow blades to coast to a stop. Repeat for number of cycles as
specified in recipe. When processing is finished push OFF button firmly.
FOR CONTINUOUS OPERATION
Rest hand on container, press proper speed button, move rotary switch to proper
speed range and press ON button. When processing is finished, push OFF button
firmly.
dC
Advertisement
