Advertisement
How to Use
Your
LED
Blender
D D D D
The four buttons marked OFF, ON, RUN and PULSE control your blender. The ON
button provides power to the unit and lights the "Speed Display Bar." The Control
Dial on the right Is turned to select the speed. Turn the knob to the right to Increase
speed and to the left to decrease speed. The LED Display Bar Indicates the selected
speeds. Match the words on the Control Panel to the number and dial the correct
speed. Remember, the words are not descriptive of the blending action but only a
reference for the speed used In the Oster recipes.
FOR CONTROLLED CYCLE OPERATION
Rest hand on container and push the ON button. Tum the Control Dial to select the
correqt speed. Press and hold the PULSE button for about two seconds, then
release and allow blades to coast to a stop. Repeat for the number of cycles
specified In the recipe. When processing Is finished, press the OFF button firmly.
FOR CONTINUOUS OPERATION
Rest hand on container and push ON button. Turn the Control Dial to select the
correct speed. As soon as the RUN button is pressed, the motor will operate. When
processing Is finished, press the OFF button firmly.
How to Use
Your "Pulse-Matic"
10 Blender
with Rotary Switch
i n * • nMt - cMf '
DDDDDDDDDD
p u l s e • nr>a«io 1 0
The 10 processing speeds are controlled by the ten pushbuttons. The rotary switch
on the right, marked PULSE-OFF/ON, controls the blending action.
FOR CONTROLLED CYCLE BLENDING OPERATION
With rotary switch in PULSE-OFF position, rest hand on container and select
speed. Push TOUCH-N-P,ULSE button in for about 2 seconds. Release and allow
the blades to coast to a stop. Repeat for number of cycles as specified in recipe.
Release of the TOUCH-N-PULSE button turns the blender off.
FOR CONTINUOUS OPERATION
Rest hand on container, select speed and turn rotary switch to "ON"positlon. When
processing is completed, turn switch to PULSE'OFF position.
Advertisement
