Table of Contents
Advertisement
EBS01079
3. The reverse indicator light fails to come on.
1. Reverse switch
• Check the reverse switch for continuity.
Refer to "CHECKING THE SWITCHES".
• Is the reverse switch OK?
YES
2. Wiring
• Check the wiring circuit from the reverse
switch to ECU (green/white) and ECU to
meter assembly (yellow/blue).
• Is the wiring circuit properly connect and
without defects?
YES
SIGNALING SYSTEM
NO
Replace the reverse
switch.
NO
Properly connect or
repair the wiring cir-
cuit.
9 - 38
3. Voltage
• Connect the pocket tester (DC 20 V) to the
meter assembly coupler as shown.
Positive tester probe → brown/yellow 1
Negative tester probe → black/white 2
Y/L Br/Y B/W
O/B
R/W
O/B
R/W
Y/L Br/Y B/W
1
2
• Set the main switch to "ON".
• Measure the voltage (12 V) of brown/yel-
low 1 and black/white 2 at the meter
assembly coupler.
• Is the voltage within specification?
YES
Replace the meter
assembly or ECU.
–
+
ELEC
NO
The
wiring
circuit
from the main switch
to the meter assem-
bly coupler is faulty
and
must
be
re-
paired.
Advertisement
Table of Contents
Troubleshooting
