Installing The Steering System - Yamaha YXR70FX Service Manual

a
15~25˚
1
STEERING SYSTEM
2. Install:
• bearing
• circlips New
• pinion gear
• oil seal New
TIP:
After centering the rack gear, make two align-
ment marks a on the pinion gear and the
steering rack assembly to mark the position of
the pinion gear. This is necessary to install the
steering joint to the pinion gear properly.
3. Apply lithium-soap-based grease to the
gear surface of the rack gear.
Lithium-soap-based grease
5 ~ 10 g (0.2 ~ 0.4 oz)
4. Adjust:
• rack gear-pinion gear backlash
M MMM M MMM M M MMM M
a. Install the pressure pad, spring, and
adjuster.
b. Tighten the adjuster 1.
Adjuster
4 Nm (0.4 m · kg, 2.9 ft · lb)
LOCTITE
c. Loosen the adjuster 15 ~ 25°.
L LLL L LLL L L LLL L
5. Install:
• dust boots
• plastic locking tie
• tie-rod end
• tie-rod end locknut

INSTALLING THE STEERING SYSTEM

1. Adjust:
• toe-in
Refer to "ADJUSTING THE TOE-IN" in
chapter 3.
8 - 54
CHAS
M MMM M M MMM M M MMM M MMM
®
L LLL L L LLL L L LLL L LLL
New
40 Nm (4.0 m · kg, 29 ft · lb)