Yamaha YXR70FX Service Manual page 329

FRONT CONSTANT VELOCITY JOINTS, DIFFERENTIAL
È
É
É
GEAR AND DRIVE SHAFT
TIP:
• Install the clip 1 into the groove in the joint
• Secure the off-set joint in a vise, and then fit
L LLL
2. Install:
• dust boot
1
• ball bearing 1
• circlip 2
2
New
• double off-set joint 3
• clip 4
TIP:
• Securely install the circlip into the groove in
• Securely install the clip into the groove in the
3
4
New
3. Apply:
• molybdenum disulfide grease
TIP:
_
Molybdenum disulfide grease is included in the
repair kit.
4. Install:
• dust boots 1
• boot bands 2, 3, 4, 5
M MMM
a. Apply molybdenum disulfide grease into the
7 - 14
shaft as shown.
the joint shaft into the off-set joint using a
hammer.
L LLL L L LLL L L LLL L
New
New
the joint shaft.
double off-set joint.
(into the ball joint assembly)
M MMM M M MMM M M MMM M
dust boots.
Molybdenum disulfide grease
60 g (2.1 oz) per dust boot (front
wheel side)
45 g (1.6 oz) per dust boot (dif-
ferential gear case side)
DRIV
L LLL L L LLL L LLL
New
M MMM M M MMM M MMM