Assembling And Installing The Rear Brake Caliper - Yamaha FZS1000(N) 2001 Service Manual

FRONT AND REAR BRAKES
EAS00644
ASSEMBLING AND INSTALLING THE REAR
BRAKE CALIPER
WARNING
S Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
S Never use solevents on internal brake com-
ponents as they will cause the piston seals
to swell and distort.
S Whenever a brake caliper is disassembled,
replace the brake caliper piston seals.
1. Install:
S brake caliper 1
(temporarily)
S copper washers
S brake hose 2
S union bolt 3
WARNING
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
"CABLE ROUTING".
CAUTION:
When installing the brake hose onto the
brake caliper, make sure that the brake pipe
a touches the projection b on the brake
caliper.
2. Remove:
S brake caliper
3. Install:
S brake pads
S brake pad pin
S brake pad clips
S brake caliper
Refer to "REPLACING THE BRAKE PADS".
4. Fill:
S brake fluid reservoir
(with the specified amount of the recom-
mended brake fluid)
4-42
CHAS
Recommended brake fluid
DOT 4
New
30 Nm (3.0 mSkg)
40 Nm (4.0 mSkg)
Recommended brake fluid
DOT 4