Assembling The Front Wheel - Yamaha FZS1000(N) 2001 Service Manual

FRONT WHEEL AND BRAKE DISCS
4-6
3. Measure:
S brake disc thickness
Measure the brake disc thickness at a few
different locations.
Out of specification ! Replace.
Brake disc thickness limit
(minimum)
4.5 mm
4. Adjust:
S brake disc deflection
a. Remove the brake disc.
b. Rotate the brake disc by one bolt hole.
c. Install the brake disc.
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
Brake disc bolt
18 Nm (1.8 mSkg)
LOCTITE
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
steps until the brake disc deflection is within
specification.
f. If the brake disc deflection cannot be brought
within specification, replace the brake disc.
EAS00539

ASSEMBLING THE FRONT WHEEL

1. Install:
S wheel bearings
S oil seals
New
a. Install the new wheel bearings and oil seals
in the reverse order of disassembly.
CAUTION:
Do not contact the wheel bearing inner race
1 or balls 2 . Contact should be made only
with the outer race 3 .
NOTE:
Use a shocket 4 that matches the diameter of
the wheel bearing outer race and oil seal.
CHAS
R