Installing The Steering Head - Yamaha FZS1000(N) 2001 Service Manual

STEERING HEAD
b. Remove the bearing race 3 from the lower
bracket with a floor chisel 4 and hammer.
c. Install a new rubber seal and new bearing
races.
CAUTION:
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
S Always replace the bearings and bearing
races as a set.
S Whenever the steering head is disassembled,
replace the rubber seal.
4. Check:
S upper bracket
S lower bracket
(along with the steering stem)
Bends/cracks/damage ! Replace.
EAS00683

INSTALLING THE STEERING HEAD

1. Lubricate:
S upper bearing
S lower bearing
S bearing races
Recommended lubricant
Lithium soap base grease
2. Install:
S lower ring nut 1
S rubber washer 2
S upper ring nut 3
S lock washer 4
Refer to "INSPECTING THE STEERING
HEAD" in chapter 3.
3. Install:
S upper bracket
S steering stem nut
NOTE:
Temporarily tighten the steering stem nut.
4. Install:
S front fork legs
Refer to "FRONT FORK".
NOTE:
Temporarily tighten the upper and lower bracket
pinch bolts.
4-60
CHAS